Draw-Tite 75210 MAX-FRAME RECEIVER - Manual

Installation Instructions
Dodge Sprinter
Freightliner Sprinter
Part Numbers:
33089
75210
87647
Hitch Shown In Proper Position
Equipment Required:
Wrenches: 18mm, 3/4
Drill Bits: None
For vehicles without factory step bumper, skip down to step 2.
1.
Remove fasteners which attach bumper mounting bracket to vehicle frame, one each side, and discard (see Figure 2).
2. Raise hitch into position and secure with fasteners provided with hitch as shown in Figure 1. Tighten all ½-13 GR5 fasteners
with torque wrench to 75 lb.-ft.
Note: On vehicles with factory step bumper, bumper mounting bracket will be re-attached at original position with fasteners
provided with hitch.
Tighten all ½-13 GR5 fasteners with torque wrench to 75 lb.-ft.
z 2005 Cequent Towing Products Sheet 1 of 3 75210N 11-11-05 Rev. C
1 Qty. (8) ½-13 x 4” Hex Bolt 3 Qty. (8) ½ Conical Toothed Washer
2 Qty. (8) ½ Flat Washer 4 Qty. (8) ½-13 Hex Nut
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Fastener Kit: 75210F
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Hitch type
Max Gross
Trailer WT (LB)
Max Tongue
WT (LB)
Weight Distributing 7500 750
Weight Carrying
Ball Mount
5000 500
Wiring Access Location: SUV3, SUV4
Form: F205 Rev A 5-6-05
Step Bumper
Mounting Bracket
Remove fastener
And discard
Figure 2
Removal of step bumper
Mounting fastener
Figure 1
Fasteners Typical
Both Sides
Vehicle Frame
43
21