Analog Way Tetra-VIO - Manual (Page 29)

TETRA VIO Chapter 6 : REMOTE CONTROL SOFTWARE (continued)
6-3. COMMUNICATION SETUP (continued)
• CASE OF LAN PORT:
- With the front panel display menu of the device, verify the configuration of the LAN communication port
(CONTROL > LAN setup), then activate the LAN communication port (CONTROL > RS232/LAN > LAN).
- With the Controls menu of the software, select RS232/LAN setup. Then in the Connection Configuration
window select the UDP or TCP protocol and select the needed parameters. The software will also display Device
connected.
NOTE: To verify the LAN status of your device: Select LAN status in the Controls menu.
6-4. USING THE SOFTWARE
 Click on the Input button and select the Signal Type for each input. Then make the others adjustments (H sync
load, Audio...).
 Click on the Output button and select the Output format and output rate. Then make the others needed adjustments.
PAGE 29