Acer 700 Series - Manual (Page 82)

7-6 AcerRouter 700 Series User Guide
The new password is configured. Your new password will take effect the next time
you logon.
"The port number should be 1 ~65535"
The port number entered in a filter rule should be in the range of 1 to 65535.
"The profile name is used by another profile"
A duplicated profile name is entered. Profile names must be unique.
"There is an active window monitoring the system status on
"xxx.xxx.xxx.xxx"."
A system status monitoring window is opened on the PC with the indicated IP address
(xxx.xxx.xxx.xxx). Only one system status monitoring window is allowed at a given
time.
"The specified tunnel is incoming only"
A tunnel profile defined as "Incoming Only" cannot be used in an outgoing VPN
profile.
"The SpeedDial number should start with a non-zero number"
An extension number or a SpeedDial number cannot start with a zero ("0").
"The system is disconnecting."
A "disconnect" button is pressed, while the system is in the process of disconnecting
an active modem link.
"The system time has been configured successfully"
The AcerRouter time has been configured successfully.
"The user name already exists. Please change the user name"
A duplicate user name is entered.Dial-In user names must be unique.
"Tunnel does not exist."
This message is displayed when an attempt is made to delete a non-existent tunnel.
"Value for idle time is invalid - choose between [0, 3600]"
The value for the idle time parameter was entered incorrectly. The correct values are 0
if no idle timeout is desired, or one to 3600 indicating the number of seconds since the
link has not carried any data traffic before it is automatically disconnected.
"Voice port A extension number unspecified"
An extension number for voice port A is required. It can be any number up to eight-
digit decimal numbers. The number cannot be the same as any other voice port or