Acer 700 Series - Manual (Page 38)

3-18 AcerRouter 700 Series User Guide
Profiles
If you press the Advanced button from the above Connection Profile
Configuration screen screen appears.
Step 1 Set any of the following parameters:
Note: The IPX options shown in this screen only appear if you selected Share
NetWare (IPX) Resource on the SMART Configuration screen.
Data Service: choose 64K, 56K, or Auto. Select Auto unless you know
the speed required by the other end of the connection requires either 64K
or 56K.
Caller ID Authen: select Yes if you want the AcerRouter 700 to check the
caller ID before accepting the call. This service may require a special agre
ement with your ISDN service provider.
Caller ID Number: if you enabled Caller ID Authentication, enter the expe
cted Caller ID Number in this field.
STAC Compression: allows outgoing data to be compressed to achieve
Connection Profile Configuration
CANCEL OK
Idle Timeout (0-3600 seconds) 120
(Optional) Remote IP Address
Remote IP Netmask
Remote IPX Network Number
Remote Office Access by ISDN
IP RIP Enable Disable
Enable IP
. . .
. . .
Caller ID Authen. Yes No
Caller ID Number
Data Service
STAC Compression Yes No
Auto
Yes No
IP RIP/SAP Enable Disable
Enable IPX Yes No
Set as IPX Default Route Yes No
Enable Bridging Enable Disable
Use for Internet Access as well Yes No
MULTILINK
Enable encryption No DES