Acer 700 Series - Manual (Page 79)

AcerRouter 700 Series User Guide 7-3
This message is displayed when an attempt is made to disconnect an inactive modem
port.
"Interface is not available"
An invalid interface type was specified during an IP filter configuration.
"Invalid Filter IP Address"
This message is displayed when an IP address with a syntax error is entered. An IP
address should be a set of four three-digit numbers. Each three-digit number should
be between 0 and 255, inclusive. For example, a correct IP address is 192.168.100.2.
"Invalid Filter Name"
This message is displayed when the entry for filter name is empty or not acceptable.
"Invalid tunnel name"
This message is displayed when a tunnel name entry is empty or not acceptable.
"Invalid tunnel remote IP Address"
This message is displayed when an IP address with syntax error is entered in a tunnel
configuration. An IP address should be a set of four three-digit numbers. Each three-
digit number should be between 0 and 255, inclusive.
"Invalid tunnel remote system name"
Each tunnel configuration requires a remote system name for authentication. If a
remote system name is not provided or is invalid, this message will be displayed.
"Invalid tunnel parameters"
This message is displayed if one or more tunnel profile parameters are invalid.
"IP Address is invalid."
The IP address entered as the AcerRouter’s public or private address was not valid.
"Not a static route"
The message is displayed when attempt to delete a non-static route in the IP Routing
Table. Only Static Routes may be deleted.
"Management session time out"
The message is displayed when HTTP management session is idle for more than the
default time out of 10 minutes, or the configured time out.
"Phone number limits characters to [0123456789,;-0]
An invalid character has been entered in the phone number field. The acceptable
phone number characters are numbers from 0 to 9, and the characters "[", "]", ",", ";",
"-".