CEMB USA N500 - Manual (Page 87)

Codes for Cemb PoInTer certificates D - 1
Appendix D
Codes that can be used in models for
certificates obtained using the CEMB
PoInTer program.
When the certificate is created, the CEMB PoInTer software automatically replaces some
of the default codes in the model (#x# format) with corresponding information, related to
the measurements displayed at the time.
To ensure that they are replaced correctly, only the following codes should be used:
#1# Current date
#2# Current time
#3# Notes/comments/analyses
#4# Image of the graph (or graphs) displayed
#10# Type of graph (FFT, wave, monT, monV)
#11# Type of measurement (Pk, PP, RMS)
#50# Unit of measurem. for the x axis (valid for all measurements displayed)
#51# Date/Time when Measurement 1 was taken
#52# Date/Time when Measurement 2 was taken
#53# Date/Time when Measurement 3 was taken
#101# System that measurement 1 is taken from
#102# System that measurement 2 is taken from
#103# System that measurement 3 is taken from
#151# Station that measurement 1 is taken from
#152# Station that measurement 2 is taken from
#153# Station that measurement 3 is taken from
#201# Machine that measurement 1 is taken from
#202# Machine that measurement 2 is taken from
#203# Machine that measurement 3 is taken from