CEMB USA N500 - Manual (Page 52)

7 - 10 Balancer mode
Unbalance measurement and calculation of the correction
In appearance the UNBALANCE MEASUREMENT page is very similar to the calibration
page:
and the following information is given:
1 – number and name of the balancing program (when loaded from the archive),
otherwise ----
2 – current speed of rotation, in RPM
3 – layout of the position of the sensors and correction planes on the rotor
N.B.
This representation is approximate only; the sensors and correction planes can be
chosen in any position relative to each other (external sensors or sensors inside the
planes, ... ) since the calibration serves especially for determining correct
parameters for balancing in any configuration..
2
3
6
7
1
4
5
8
1
4
5
8
2
3
6
7