CEMB USA N500 - Manual (Page 50)

7 - 8 Balancer mode
Execution of measurement
To start the measurement in any of these steps, press ; a pop-up panel appears
showing, in real time, the quality of the current measurement (for each channel).
The higher is the level of the bars, the better will be the quality of the measurement (which
is averaged over time). After reaching the required level, stop the measurement again by
pressing
.
If the operator decides to accept the value, then he must press corresponding to
the option , which flashes in order to warn the operator the importance of
pressing it.
When the measurement is accepted, the corresponding calibration step is indicated as
complete
.
N.B.
Unstable signals produce measurements whose quality is unable to reach acceptable
levels; under these conditions, it is advisable to increase filter accuracy
(see 7-3 Filter accuracy) and consequently repeat the entire procedure.
N.B.
If the quality of a particular measurement has been altered by a special event (e.g.
an impact), the time required to go back to it could be excessively long; to speed it
up, the measurement can be reset manually by pressing .