CEMB USA C88 (B) - Manual (Page 30)

I 0709 - 30 GB
5.3.7.3 - POSITIONING ►
Automatic positioning enable of the outside or static side at the end of the spin.
5.3.7.4 - ENABLING OF SERIAL OUTPUT RS232C ►
This option enables/disables the sending of the measured unbalance and phase values to serial output RS232C.
Transmission speed
9600 baud
Data format 1 bit Start
8 bit Data
None parity
1 bit Stop
At the end of each unbalancing measuring spin, the balancing machine transmits the data regarding the measured
unbalance. The items of data transmitted via serial line are in ASCII format and are separated between each other by
the character (0x0d).
Sending sequence is as follows:
- 00000
- Value of correction weight, left side
- Correction phase, left side
- Value of correction weight, right side
- Correction phase, right side
The fi rst 5 zero bytes represents the start of transmission message. The correction values are expressed in grams, in
steps of .1 gram.
The phase values are expressed in degrees, in the range 0 ÷ 359.
5.3.7.5 ► - PRINTER ENABLING (OPTIONAL)
Enable/disable printer and relative print options.
I F THE OPTIONS RS232 SERIAL PORT AND PRINTER ARE ENABLED AT THE SAME TIME , BOTH WILL MALFUNCTION .
5.3.7.6 - WHEEL LOCKING ENABLE ►
Enables/disables wheel locking in the correction position (
WHEEL LOCKING
).
The possible options are:
OFF: disabled
ON: enabled
ALUS : enables wheel locking in position for the ALUS correction mode only.