CEMB USA C88 (B) - Manual (Page 20)

I 0709 - 20 GB
4. At this point, two indications appear on screen for positioning of the unbalance correction spokes.
5. Position the spokes indicated on screen in the 12 o’clock position and correct with the value displayed.
Any error in this procedure is clearly shown on screen.
Always follow the information provided by the wheel to optimise correction.
4.7.5 - OUT OF BALANCE OPTIMIZATION ►
The symbol is displayed automatically for static out-of-balance exceeding 30 grams (1.1oz).
The program allows total wheel out-of-balance to be reduced by compensating, when possible, tyre and rim out-of-
balance values. It requires two runs, rotating the tyre on the rim on the second run.
Having performed a run, press +
1
and follow the on-screen instructions
4.7.6 - CORRECTION MODE ►
After having performed automatic measurement of the inner side, it is possible to place the correction weights as
required by pressing pushbuttons
In the event of automatic measurement of both sides, if the difference between the inner and
outer diameters is greater than or equal to 2”, the system sets the inner side spring weight.
To modify this presetting, press the button.
To display static unbalance, press the button on the measurement screen (for ALUS static, the inner side
diameter is always considered).