CEMB USA C88 (B) User Manual
Page 17
I 0709 - 17
GB
4.7 - MEASUREMENT RESULT
►
After positioning and locking the wheel, apply the weight vertically at the top. When the beep signal is enabled (
ACOUSTIC SIGNAL
), reaching of the correction position is accompanied by a “beep”.
If the out-of-balance is less than the chosen threshold value, “0K” appears instead of the out-of-balance value to
indicate, on that particular side, that the wheel is in tolerance; the residual out-of-balance can be displayed by
pressing the button
, with an accuracy of 0.5 g (0.1 oz.)
The following buttons are enabled:
display of residual out-of-balance.
selection of correction mode (STATIC/DUAL SURFACE). When the mode is changed, the
unbalance values are recalculated automatically on the basis of the previous spin.
Simultaneous display of the dynamic+static unbalance can be enabled through the special
function in Setup (see par.
STATIC ALWAYS ENABLED
).
prints the balancing certifi cate (option)
: eccentricity measurement graph (OPTIONAL).
N.B
:
1. The symbol above the key is displayed in yellow if the fi rst harmonic eccentricity exceeds the
limit set in the setup parameters (
FIRST HARMONIC LIMIT
).
2. When this push button is held down for more than 1.5 seconds, eccentricity measurement is tempora-
rily disenabled (enabled in
SETUP
). To re-enable eccentricity measurement, press push button [4] again
for more than 1.5 seconds. Every time the machine is switched on, the status of eccentricity measure-
ment refl ects the settings in
SETUP
.
unbalance split function enable
acquisition of new dimensions (
AUTOMATIC POSITION REPEATER
)
enable indication of the longitudinal position of the out-of-balance (
INDICATION OF EXACT
CORRECTION WEIGHT POSITION
)
selection of special functions
balancing
run.
N.B.: if the machine remains on this screen without being used for more than the time preset
in the Setup parameters (
SCREEN SAVER
), the screen automatically returns to the screen-saver.
SONAR STATUS RADIAL
ECC. (eccentricity)
SONAR STATUS
LATERAL ECC.
SONAR STATUS:
GREEN: in measuring position
RED: out of measuring range
Inside unbalance
indicator
Outside unbalance
indicator
Static unbalance
indicator