CEMB USA C88 (B) - Manual (Page 13)

I 0709 - 13
C
GB
8. Release the pedal to enable wheel release;
9. Move the wheel outside the spindle axis and push the lift to the bottom (using your foot - Photo 5) until reaching
the rest position (down); this function can be executed automatically by pressing the button indicated in Fig. C (as
shown in Photo 6).
10. Remove the wheel from the lift, load the next one and repeat the procedure from step 1.
If the cycle is interrupted for any reason, proceed as follows:
If the wheel is mounted, remove it manually; 1.
Hold the button indicated in Fig. A down for more than 2 seconds to enable the lift reset cycle. 2.
WARNING: IN SOME CASES, THE LIFT MIGHT MOVE SLOWLY UNTIL THE PNEUMATIC SYSTEM IS COMPLETELY EMPTY .
Repeat the sequence from step 1. 3.
Photo 5 Photo 6
Photo 4