Avaya Cajun P550 - Manual (Page 40)

2-32
Chapter 2
Cajun P550/P880 Manager User Guide
11. From the Hunt Group pull-down menu, select a hunt
group for which this port will be a member. Refer to the
Cajun P550/P220 Switch Operations Guide for more information
on hunt groups.
12. From the Spanning Tree pull-down menu, select to Enable
or Disable spanning tree protocol on this port.
13. From the Fast Start pull-down menu, select to Enable or
Disable. When enabled, Fast Start mode ports begin
forwarding traffic without waiting for the spanning tree
negotiation to complete. Fast start eliminates the waiting
time of listen and learn states. Ports immediately enter the
forward state.
14. From the Known Mode pull-down menu, select to Enable
or Disable. Selecting Enable suppresses the packets with
unknown unicast destination addresses flooded to the port.
For example, if a known end-station or file server is
connected to the port, there’s no need to flood unknown
unicasts to the port. You must manually enter a static MAC
address for the station actually attached to the port.
15. From the 3Com Mapping Table pull-down menu, select the
3Com Mapping Table to specify how many incoming
tagged frames from 3Com equipment are mapped to Avaya
VLANs. The default is 3ComDefault.
16. From the Mirror Port pull-down menu, select Enable to
display the Mirror Port.
* Note: This is a Fast Ethernet only option.
17. Click APPLY to save your changes, or CANCEL to restore
previous settings.
Configuring
Non-VLAN
Switch Port
Parameters
To configure non-VLAN switch port parameters:
1. Start Cajun P550/P880 Manager. For information about
starting the Cajun P550/P880 Manager, refer to "Starting the
Cajun P550/P880 Manager" in this chapter.
2. Right-click a port in the switch representation in the Full
View field.
3. From the Port pull-down menu, select Switching
Configuration. The Switch Port Configuration dialog box of
the Cajun Switch Web Agent opens (Figure 2-5).