Agilent Technologies 75000 SERIES B - Manual (Page 17)

Example: Form C
Switch Channel
Lists/Ranges
Channel Lists:
CLOS (@100,112) Close channels 00 and 12 on card
01
OPEN (@203,210) Open channels 03 and 10 on card
02
Channel Ranges:
OPEN (@100:115) Open all channels on card 01
SCAN (@100:115) Scan all channels on card 01
Initial Operation
An example program follows which uses BASIC and the SCPI language to
get you started using the Form C Switch. The example assumes an Agilent
9000 Series 200/300 (or equivalent) computer and a General Purpose
Interface Bus (GPIB). (GPIB is the implementation of the IEEE 488.2-1987
standard.)
This program closes channel 02 of a Form C Switch at logical address 120
(secondary address = 120/8 = 15) and queries the channel closure state. The
result is returned to the computer and displayed (1 = channel closed, 0 =
channel open). See the Agilent 75000 Series B Installation and Getting
Started Guide for information on addressing.
Example: Close Form C Switch Channel
10 OUTPUT 70915;"CLOS (@102)" ! Close channel 02
20 OUTPUT 7091 5;"CLOS? (@102)" ! Query channel 02 state
30 ENTER 70915;Value ! Enter result into Value
40 PRINT Value ! Display result
50 END
Chapter 1 Getting Started with the Agilent E1364A 15