DE-STA-CO F5-B AC Inverter Drive - Manual (Page 33)

33
4.1.1 Keypad
Pressing ENTER only clears the fault message in the display. In
the Inverter status display (CP. 2), the fault is still displayed until
the inverter has been reset. In order to reset the fault itself the
cause must be identified and removed, than a reset signal applied
to terminal 16, F5-Basic, or a power-on reset (cycle supply voltage
off and then on) must occur.
error
When switching on the KEB COMBIVERT F5, the value of parameter CP.1
appears in the operator display. (see "Drive Mode" to switch the keypad
function)
The function key
(FUNC) changes
between the
parameter value and
parameter number.
With UP ( ) and
DOWN ( ), the
value of the
parameter number
is increased or
decreased.
Generally; when a value is changed, parameter values are immediately
accepted and stored nonvolatile. However, with some parameters it is not
useful that the adjusted value is accepted immediately. In these cases the
adjusted value is accepted and stored nonvolatile by pressing ENTER.
If a drive fault occurs during operation, the display changes to the drive
fault message. The drive fault message in the display is cleared by
pressing ENTER.
Operation of the Drive