DE-STA-CO F5-B AC Inverter Drive - Manual (Page 21)

21
Limit Switch
Limit switch
Keyway
3.3.8 CAM Gear Box
A standard Roller Gear unit with the CAM &
Limit Switch mounted on the correct keyway
position directly opposite of the output shaft,
90 degrees(clockwise or counter clockwise)
from the CAM Lobe. The CAM & Limit Switch
may also be mounted on the reducer. *If the
unit has a “Type II” motion, a special Limit
Switch CAM is needed with one extra Lobe,
180 degrees from the first Lobe. (as shown)
A standard right angle unit with the CAM &
Limit Switch mounted on the housing has a
correct keyway position directly opposite of the
CAM Lobe. CAM & Limit Switch may also be
mounted on the reducer.
A standard parallel unit with the CAM & Limit
Switch mounted on the housing has a correct
keyway position directly opposite of the output
shaft, 90 degrees (clockwise or counter
clockwise) from the CAM Lobe. CAM & Limit
Switch may also be mounted on the reducer.
Keyway Type II Extra
CAM LOBE
Limit switch
Installation and Connection
Keyway
For the correct dwell location of the cam or input shaft keyway see the IMC
CAMCO-Ferguson assembly drawing for your unit.