AVTECH Room Alert 4ER Monitor (RA4E-ES1-RAS) - Manual (Page 13)

AVTECH Software Inc.
Room Alert 4E Installation
Step 5: Check Room Alert 4E Firmware Version
Open the AVTECH Device Discovery Utility and click the ‘Search’ button. When the Room Alert 4E
unit is located, select it and click the ‘Web’ button. If you are unable to locate your Room Alert 4E unit
because UDP broadcast packets are blocked on your network, simply type the IP address of the Room
Alert 4E unit in the location bar of a web browser.
NOTE: If the ‘Status’ screen does not load sensor data, be sure that a proxy or Microsoft ISA (Internet Security and
Acceleration) server is not blocking traffic to or from the Room Alert 4E unit.
After the ‘Status’ screen has loaded and is fully displayed, click the ‘Room Alert 4E vX.X.X’ link in the
top right hand corner. If the pop-up that loads says a more current version is available, then follow the
instructions in the ‘Upgrading Firmware’ section of the ‘Advanced Topics’ chapter of this manual.