Atec Rohde-Schwarz-ESU-40 - Manual (Page 13)

Version 02.00, October 2007 R&S ® ESU EMI Test Receiver 13
Inputs and outputs (rear panel)
IF 20.4 MHz BNC female
Impedance 50 Ω
RBW ≤30 kHz 1.67 × resolution bandwidth, min. 2.6 kHz
RBW = 50 kHz, 100 kHz 400 kHz
Bandwidth
200 kHz ≤ RBW ≤10 MHz equal to resolution bandwidth
RBW ≤100 kHz, FFT filter,
mixer level > –70 dBm –20 dBm at reference level Level
RBW = 200 kHz to 10 MHz,
mixer level > –50 dBm 0 dBm at reference level
Video output BNC female
Impedance 50 Ω
Output voltage RBW ≥200 kHz, logarithmic scaling,
full scale 0 V to 1 V (EMF)
Reference output BNC female
Impedance 50 Ω
internal reference 10 MHz Output frequency
external reference same as reference input signal
Level >0 dBm, nominal
Reference input BNC female
Impedance 50 Ω
Input frequency range 1 MHz ≤ f
in
≤ 20 MHz, in steps of 1 Hz
Required level >0 dBm from 50 Ω
Sweep output BNC female
Output voltage 0 V to 5 V, proportional to displayed
frequency
External trigger/gate input BNC female
Trigger voltage 0.5 V to 3.5 V
Input impedance ≥10 kΩ
IEC/IEEE bus control interface in line with
IEC 625-2 (IEEE 488.2)
Command set SCPI 1997.0 or HP8566 compatible
Connector 24-pin Amphenol female
Interface functions SH1, AH1, T6, L4, SR1, RL1, PP1, DC1,
DT1, C0
LAN interface 10/100BaseT, RJ-45
upper connector type A plug, version 1.1 USB interface
lower connector type A plug, version 2.0
Serial interface RS-232-C (COM), 9-pin female connectors
Printer interface parallel (Centronics compatible)
Mouse interface PS/2 compatible
Connector for external monitor (VGA) 15-pin D-Sub