Atec Agilent-8753E - Manual (Page 6)

6
System performance summary
HP 8753E (75-ohm systems) type-N test ports
1. 90 dB, 30 kHz to 50 kHz.
2. 100 dB, 300 kHz to 16 MHz due to fixed spurs.
3. These measurement uncertainty curves utilize an RSS model for the contribution of random
errors such as noise, typical connector repeatabilities, and test set switch; with a worst-case
model for the contributions of dynamic accuracy and residual systematic errors.
4. The graphs shown for reflection measurements apply to either a one-port device or a two-port
device with more than 6 dB insertion loss.
5. Typical performance.
6. Typical below 300 kHz.
7. 15 dB from 30 to 50 kHz.
The following specifications describe the system perfor-
mance of the HP 8753E network analyzer with an inte-
grated 75-ohm S-parameter test configuration. System
hardware includes the following:
Network analyzer HP 8753E Option 075
Calibration kit HP 85036B
Test-port cables HP 11857B
Dynamic range
These specifications apply to transmission measurements
in the 30 kHz to 3 GHz frequency range at 10 Hz IF BW
with full two-port error correction. Dynamic range is
limited by maximum receiver input level and the receivers
noise floor.
System dynamic range
30 kHz to 300 kHz 95 dB 1,6
300 kHz to 1.3 GHz 105 dB 2
1.3 GHz to 3 GHz 105 dB
Typical measurement uncertainty 3
The following graphs show the typical measurement
uncertainty for the HP 8753E over the full frequency range
using full two-port error correction.
Transmission measurements
Magnitude
Reflection measurements 4
Magnitude
Measurement port characteristics
The following specifications show the residual HP 8753E
system uncertainties for uncorrected performance and
after accuracy enhancement using full two-port error cor-
rection. These characteristics apply for an environmental
temperature of 25 ± 5° C, with less than 1° C deviation
from the calibration temperature.
Frequency Range
Corrected 5 30 kHz - 300 kHz 300 kHz - 1.3 GHz 1.3 GHz - 3 GHz
Directivity 48 dB 48 dB 43 dB
Source Match 47 dB 41 dB 35 dB
Load Match 48 dB 48 dB 43 dB
Reflection tracking ±0.004 dB ±0.010 dB ±0.019 dB
Transmission tracking ±0.018 dB ±0.015 dB ±0.033 dB
Uncorrected 5
Directivity 20 dB 7 35 dB 30 dB
Source Match 10 dB 16 dB 16 dB
Load Match 14 dB 18 dB 16 dB
Reflection tracking ± 2.0 dB ± 1.5 dB ± 1.5 dB
Transmission tracking ± 2.0 dB ± 1.5 dB ± 1.5 dB
Crosstalk 90 dB 100 dB 100 dB
Phase
Phase