General information (continued), Rear panel – Atec Agilent-PNA Series User Manual
Page 14
General information (continued)
Description
Supplemental information
Display
21.3 cm (8.4 in) diagonal color active matrix LCD; 640 (horizontal) x 480 (vertical)
resolution; 59.83 Hz vertical refresh rate; 31.41 Hz horizontal refresh rate
Display range
Magnitude
±200 dB (at 20 dB/div), max
Phase
±180°, max
Polar
10 pUnits, min; 1000 Units, max
Display resolution
Magnitude
0.001 dB/div, min
Phase
0.01°/div, min
Marker resolution
Magnitude
0.001 dB, min
Phase
0.01°, min
Polar
0.01 mUnit, min; 0.01°,min
Rear panel
Test port bias input
BNC, female
Maximum voltage
±30 VDC, typical
Maximum current (no degradation in
±200 mA, typical
RF specifications)
Maximum current
±1 A, typical
10 MHz reference in
BNC, female
Input frequency
10 MHz ±1 ppm, typical
Input level
–15 dBm to +20 dBm, typical
Input impedance
200
Ω, nominal
10 MHz reference out
BNC, female
Output frequency
10 MHz ±1 ppm, typical
Signal type
Sine wave, typical
Output level
10 dBm ±4 dB into 50
Ω, typical
Output impedance
50
Ω, nominal
Harmonics
< -40 dBc, typical
VGA video output
15-pin mini D-Sub, female; drives VGA-compatible monitors
GPIB
24-pin D-24, female; compatible with IEEE-488
Parallel port (LPT1)
36-pin, mini-D, 1284-C connector; provides connection to printers or any other
parallel port peripheral
Serial port (COM1)
9-pin D-Sub, male; compatible with RS-232
USB Port
Type-A configuration (4 contacts inline, contact 1 on left), female
Contact 1
Vcc: 4.75 to 5.25 VDC, 500 mA max
Contact 2
–Data
Contact 3
+Data
Contact 4
Ground
LAN
10/100BaseT Ethernet; 8-pin configuration; auto selects between the two data rates
External detector input
BNC, female; input from an external, negative polarity diode detector provides ALC
for a test port remote from instrument’s front panel
Input sensitivity
–500 mV yields approximately –3 dBm at detector's input, typical
Bandwidth
50 kHz, typical
Input impedance
1 k
Ω, nominal
14