Fig. 7-2, the 18-pin jumper – Alpha Technologies AlphaNet DSM Series DOCSIS User Manual

Page 46

745-814-B0-001, Rev. A

7.0

Hardware Installation, continued
7.2

Hardware Installation Procedure, continued

6. Locate the 18-pin jumper and insert the long side of the jumper firmly into the

side of the inverter module.

7. Unpack the XP-DSM. If not yet done, record the MAC addresses from the front

of the unit, and report it to the network manager for network provisioning (see

9. Secure the XP-DSM to the inverter module by tightening the two captive screws.

10. Reinstall the inverter module and reconnect the ribbon cable. Make front panel

connections (tamper, RTS, battery sense, etc.).

8. Line up the 18-pin jumper with the XP-DSM connector and connect the unit to the

inverter module.

Insert Long Side Into Inverter Module

Inverter Module

Fig. 7-2, The 18-pin Jumper

Fig. 7-3, Connecting the Transponder to the Inverter Module