Alpha Technologies FlexPoint AX Series - Manual (Page 21)

21 010-318-C0-007, Rev. G
1. Mount the Home Converter horizontally in a convenient interior
location near an AC outlet, using two (2) 8-32 pan head screws
(for placement over studs) or Molly bolts (for mounting on
drywall) long enough to support a 1-lb. unit.
2. Strip 1/4" from the cable wire ends. Connect the cable from the
Power-Ring into the 3-pin plug in the following order:
Pin 1, white (return), Pin 2, black (12V) Pin 3, green (control).
Tighten the plug screws with a 0.100" jeweler’s screwdriver. To
reduce the potential for a short circuit, verify no bare wire
is showing, or loose strands of wire are present between
the cables.
3. Verify orientation of plug and snap the 3-pin plug into the Home
Converter. Do not force the plug into the converter.
4. Secure the cable to the base of the converter by threading a
cable tie through the two holes on the extension at the base of
the Converter. Tighten the cable tie and trim the excess.
4.2 Installing the Power-Ring Converter, continued
5. Use fl at-bladed screwdriver to remove blanking plate from Power-Ring.
6. Insert AX-30 module into meter base. The module will lock into place when fully inserted.
Blanking Plate
AX-30
Pin 1
.
To ONT
Minimize Gap
Strain
Relief
Insert
screwdriver here,
twist to remove
plate
If the Power-Ring Converter is part of an Outdoor Non-UPS confi guration, proceed to Section 6.1, “Activating
the Power-Ring Converter”. Otherwise, continue to Section 5.0, “ Installing the Battery Module”
NOTE:
Refer to the NOTE in Section 2.0, “Applications” for wire size and distance.
NOTE:
If the Home Converter is part of an Indoor to Outdoor Non-UPS confi guration, proceed to Section 5.2,
“Activating the Home Converter".
NOTE:
4. Installation
4.3 Installing the Home Converter