Extron Electronics MAV 44_48_84_88 Series User Guide - Manual (Page 39)

3-15 MAV 44 / 48 / 84 / 88 Matrix Switchers • Operation
2 . Press and release the Output 3 button (figure 3-24).
7 6 2 4 1
INPUTS
OUTPUTS
8 3
6 4 5
5
I/O
AUD
VID +dB
- dB
Press and release the Output 3 button.
The Output 3 LED lights to indicate that output 3 is selected and it is receiving video or video
and audio. The source (or sources, if audio is broken away) is indicated by the Input LED(s).
The Output 1, Output 4, and Output 8 LEDs also light to indicate that they are receiving video
from the indicated input. These unselected outputs may or not be receiving audio, you cannot
tell from these indications.
The Input 5 LED lights to indicate that this input's
video is tied to output 3 (and the other lit outputs).
The audio LED blinks
to indicate that, for at
least one tie, audio is
routed from a different
source or not tied at
all (audio breakaway).
Figure 3-24 — Select an output
Steps 3 and 4 can be performed on an audio switcher only. If you have a video-
only switcher, allow the 5-second input and output button timeout to deselect
the input.
3 . Press and release the I/O button (figure 3-25).
2
OUTPUTS
1 8 6 5 4 3 7
I/O
AUD
VID +dB
- dB
4
INPUTS
6 4 5
Press the button
to deselect audio.
The video LED lights
when video is selected.
The audio LED is off
when audio is deselected.
The Output 3 LED lights to indicate that output 3 is selected and it is receiving video. The
source is indicated by the Input LED(s).
The Output 1, Output 4, and Output 8 LEDs also light to indicate that they are receiving video
from the indicated input.
The Input 5 LED lights to indicate that this input's video is tied
to output 3 (and the other lit outputs).
Figure 3-25 — Deselect audio to view video ties only