Preliminary – Extron Electronics IPCP Pro Series User Guide User Manual
Page 46
IPCP Pro Series • Index
40
I
IP address
LAN port defaults 16
resetting to default (Reset All IP
Settings mode) 24
IR drivers
IR driver file type (.eir files) 35
IR emitters
wiring for use with IR output
ports 17
IR learning
distances and angles 10, 11
frequencies accepted by the
controller 11
receiver/sensor location
and use 10
IR output ports
use and wiring 17
IR signal sensor (IR learning receiver)
location, use, reception angle 10
L
LAN (IP) ports
cabling, LEDs, and default
settings 16
default settings 16
latching
relay description and wiring 18
licensing
for third-party software 36
Global Configurator
Professional 6
LinkLicense, use with third party
devices 2
LinkLicense
using with a third party device 2
M
MAC address
description 16
location on panel 12
memory expansion (SD card) port
troubleshooting 31
modes
reset modes and procedures 22
mounting
UL rack mounting guidelines 11
P
password
default 16
port mapping
resetting to default 24
troubleshooting 30
wiring, polarity, requirements
input power, external power
supply 13
input power, internal power
supply 13
output power 14
pulsed
relay description and wiring 18
R
rack mounting
UL rack mounting guidelines 11
relay ports
latching: description and
wiring 18
pulsed contact: description
and wiring 18
Reset button
Reset button and LED location 11
using to reset the unit 22
resetting the unit
manual reset modes 22
RS-232, RS-422, RS-485 default
protocol and COM port pin
configurations 15
S
serial communication protocol
COM port defaults 15
serial ports
wiring COM ports 15
wiring IR/Serial ports 17
straight-through cable (wiring and
when to use) 16
subnet
default value 16
definition of subnet mask 34
resetting to default 24
system requirements 6
T
third-party software
list of software licenses 36
TouchLink Pro touchpanel
as part of a system with
an IPCP 2
touchpanel
as part of a system with
an IPCP 2
data connections 30
device control connections and
configuration 31
eBUS connections and
configuration 31
memory card use 31
power connections 30
U
Underwriters Laboratories (UL)
UL rack mounting guidelines 11
updating the firmware 38
username
default 16
PRELIMINARY