Pc system requirements, About global configurator (with, Gc professional and gc plus modes) – Extron Electronics IPCP Pro Series User Guide User Manual
Page 12: Preliminary
IPCP Pro Series • Introduction
6
About Global Configurator (with GC Professional and GC Plus Modes)
Global Configurator is the software tool for network setup and configuration of an IPCP Pro
control processor. Global Configurator:
•
Loads device drivers for monitoring the status of and controlling devices within the AV
system.
•
Uploads GUI Designer layouts to touchpanels and third party touch interfaces.
•
Creates the configuration containing all the settings for the control processor and the
products with which it interacts in the AV system.
•
Generates a graphical user interface called GlobalViewer (GV) that is uploaded to the
control processor (a GlobalViewer host device) along with the completed configuration
and can be accessed as a web page.
Using GlobalViewer, users can monitor and control Extron and third-party equipment such
as projectors, displays, computer monitors, VCRs, and DVD players.
Global Configurator Professional is the licensed mode of the software.
PC System Requirements
To find the minimum hardware and software requirements for the PC you will use to
configure the IPCP Pro Series:
•
Visit the Download page (
on
website and navigate to web page for the specific software package (such as
Global Configurator and GUI Designer). Minimum PC hardware and software system
requirements are listed in the description section. In some cases, minimum device
firmware version requirements are also listed there.
•
If system requirements are not listed on the software package web page, contact an
Extron support representative.
PRELIMINARY