Connections and wiring, Power connection, Local area network (lan) connection – Extron Electronics IPL T Series Setup Guide User Manual
Page 20: Power connection local area network (lan), Connection, 14 ipl t series • setup

14
IPL T Series • Setup
Connections and Wiring
Power Connection
To connect the power supply:
1.
Insert the 2-pole captive screw connector into the power supply
receptacle on the rear panel of the controller.
SECTION A–A
Ridges
Smooth
Power Supply Output
Cord
A
A
3/16”
(5 mm) Max.
Power Supply Receptacle
DC Power Cord
Captive Screw Connector
AC Power Cord
Ground
+12 VDC
External
Power Supply
(12 VDC, 1 A )
COM1 COM2
LAN
POWER
12V
.5A MAX
FLEX I/O
2
1
3 4
1
IR
2
3
4
TX RX
TX RX
G
S
G
S
G
S
G
S
MAC: 00-05-A6-XX-XX-XX
S/N:
Figure 6.
Power Connector Wiring
2.
Connect the female end of the AC power cord into the power
supply and the male end into a 110-220 VAC outlet.
Local Area Network (LAN) Connection
Connect a patch (straight-through) Ethernet cable to the LAN port on
the rear panel if you are connecting the controller to a switch, hub, or
router on your A/V network.
Connect a crossover Ethernet cable to the LAN receptacle on the rear
panel if you are connecting the controller directly to a PC.
Local Area Network (LAN) Receptacle
COM1 COM2
LAN
POWER
12V
.5A MAX
FLEX I/O
2
1
3 4
1
IR
2
3
4
TX RX
TX RX
G
S
G
S
G
S
G
S
MAC: 00-05-A6-XX-XX-XX
S/N: