Extron Electronics DDS 100 - Manual (Page 22)

Operation, cont’d
DDS 100 Operation 3-4
Figure 8 — DDS 100 flow chart
• To reset adjustments made from within the zoom/size/pan menus,
press and release the Freeze/reset button from with any zoom/
size/pan menu.
This symbol is used to indicate the path. If either button 1 or 2 (could be Freeze or Menu)
is pressed, the path will be in the 1 or 2 direction. No button pressed = the N direction.
at left end of flow chart screens indicate path to possible alternate screens.
Alternate Screens
01 3456789
Enter or exit executive
mode by pressing the
cursor Up or Down
buttons at the same
time, or by sending an
RS-232 command. The
applicable executive
mode screen appears
for four seconds, and
then the default cycle
resumes.
If the zoom adjustment
exceeds the minimum or
maximum limit, the
applicable zoom screen
appears.
If an adjustment
exceeds the minimum or
maximum limit, the
applicable screen
appears.