Xylem Oxix Dissolved Oxygen Transmitter - Manual (Page 76)

76 GB Oxix Manual 080915
FW: 841013-009, 846001-002, 841513-009
Dissolved Oxygen Transmitter
Change device address
To change each converter's device adress it is required that you connect the
Display Unit to each converter one by one to change each converter's device
address. If neglected, a conflict between the units will arise when the RS 485
serial loop is established.
Change for example "Device 1" to "Device 2" as follows:
1. Press OK and use the up/down keys to change "1" to "2".
2. Press OK.
The Oxix
® converter ID is now changed to "2", and more converters can be
added to the Display Unit with the "Add Device" option.
Remove Device
If a device is to be removed from the Display Unit, proceed as follows:
1. Select the required device with the up/down keys.
2. Click OK to remove it.
The device is now removed from the Display unit and display returns to the
"Modbus" menu.
Change controller ID (display)
The display controller ID must be changed when several displays operate with
the same converter(s)