YSI DIQ/S 182-MOD System 182 - Manual (Page 69)

System 182 Operation
4 - 7 ba76025e01 02/2012
If you want to correct a previously selected character while entering,
select the thin arrow to the left
b and press g
. This moves the
entry mark by one digit to the left. Thus you can go back to the
required character. All characters on its right side, however, have to
be entered once again.
If you want to restart entering the characters, select the thick arrow
to the left
B and press g
.
 Numerals:
Entering numerals is made in the same way as entering characters.
The following numerals can be entered: 0..9-.
Entering" -" or "." is only allowed where it makes sense, e.g. "-" at
the first position only.
Save and quit On principle, all settings done in the entry mode are only taken over
after you selected the Save and quit item in the relevant setting table
and pressed
g
. If you exit the setting table via
m
,
e
or the Quit
menu item, all changes are ignored.
Exceptions: Date/time, air pressure and password.