YSI DIQ/S 182-MOD System 182 - Manual (Page 49)

System 182 Installation
3 - 35 ba76025e01 02/2012
Fig. 3-30 24 V AC/DC connection.
Note
The complete assignment of the terminal strip is shown in section 3.12.
Warning
No free wires must be allowed to project into the enclosure.
Otherwise there is the danger of short circuits that can cause a
fire. Always cut off any wires that are not in use as closely as
possible to the cable gland.
8 Connect wires 1 and 2 to the terminal strip. Make sure that the
cable assignment agrees with the specification on the terminal
label under the terminal strip.
9 Tighten the coupling ring (pos. 3 in Fig. 3-29).
10 Close the enclosure of the Universal Transmitter.
Terminal
labeling:
X17 X16
24V AC DC
INPUT
POWER