Xylem 10 001 262R5 AquaForce Pump Controller User Manual
Page 33
AQUAFORCE Installation, Operation, and Maintenance
27
Installation
4.10.18 Save to flash
The Save To Flash screen is displayed below:
SAVE TO FLASH
Previously Saved Data
Will be overwritten!
PROCEED: $(Y/N)
Press
YES and ENTER to save all of the user setup to the flash memory. Saving to flash will overwrite any data
that was previously saved. Saving to flash memory will save all setup information to the Flash PROM chip within
the controller
A
load from flash will have to be performed to recover this saved data. See the following section.
4.10.19 Load from flash
The Load From Flash screen is displayed below:
LOAD FROM FLASH
All Settings will be
Overwritten!
PROCEED: $ (Y/N)
Press
YES/7 and ENTER to overwrite all of the current user setup information with the data that was
previously saved to the flash memory. Loading from flash memory will load all setup information that was saved
to the Flash PROM chip within the controller.
4.10.20 Load default
The Load Default screen is displayed below:
LOAD DEFAULTS
Settings will be
Overwritten by the
defaults! PROCEED:$(Y/N)
Press
YES/7 and ENTER to overwrite all of the current user setup information with the factory defaults.
4.10.21 Display menu
Paths: Status Screens / Set up(3) / System(4) / Display(13)
The DISPLAY menu has been shown below:
Delay to Display
Status # m
Rate ##s Exit $(Y/N)
Press the next ( ) key to go to the next screen. The display now shows:
Exit $ (Y/N)
NO/0 key and ENTER key. Modify the values as desired.
▲