Acer Altos R510 - Manual (Page 92)

4 Configuring the system 80
8 Slide the board to the right until it stops. Do not pull on any
components on the board – grasp only on the edges of the board.
See letter “B” in the figure.
9 Lift the backplane from the chassis. The holes in the backplane will
slide from the matching pins in the chassis. If any of the pins
catches on the holes, it means you have not slid the board fully to
the right. See letter “C” in the figure.
Installing the SCSI or SATA Backplane
1 Observe the safety and ESD precautions at the beginning of this
book. See
“Safety Information.”
2 Power down the server and unplug all peripheral devices and the
AC power cable.
3 Remove the chassis cover. For instructions, see “Removing the
Chassis Cover.”
4 Remove the air baffle. For instructions, see “Removing the Air
Baffle.”
C
A
B