Acer Altos R510 - Manual (Page 60)

4 Configuring the system 48
Installing a SATA or SCSI Hot-swap
Hard Disk Drive
Use these instructions only if you have installed the SATA or SCSI
backplane kit. Please refer to Page 79 for details of how to install the
backplane.
1 Remove the front bezel if it is installed. For instructions, see
“Removing and Installing the Front Bezel.”
2 Press in on the green latch at the front of the hard drive carrier.
See letter “A” in the figure below.
3 Pull out on the black lever and slide the carrier from the chassis.
See letter “B” in the figure below.
4 Remove the four screws that attach the plastic retention device or
the previously installed hard drive to the drive carrier. Two screws
are at each side of the retention device or the hard drive. Store the
plastic retention device for future use.
A
B