Acer Altos R510 - Manual (Page 57)

45
15 See letter “B” in the figure below and the arrow that leads from
this letter to the component in the chassis. This component is the
air baffle that is referred to in the following steps. The letter “B”
points to the cutout that is referred to.
16 Power cables for drives installed to the right side of the air baffle
must be routed beneath the front cutout in the underside of the
air baffle. The power cable for a drive installed to the left of the
air baffle does not need to be routed under the air baffle. See
letter “B” in the figure below to identify the air baffle and the
cutout area. You may need to remove the air baffle to route cables
underneath it. To see how to remove and then install the air
baffle, see “Removing and Installing the Air Baffle. “
17 Connect the SATA power cable adapter end(s) to the rear of the
SATA drive. See letter “A” in the figure below to locate the
connector on the SATA drive.
TP0130
B
A
A
D
C
E