Acer Altos R510 User Manual
Page 85
73
6
Line up the screws on the riser assembly with the slot and the large
hole on the riser connector.
7
Press and hold the blue riser locking lever. See letter “A” in the
figure below.
8
Place riser connector onto the retention pins.
9
Slide the riser connector to the right to lock it into place.
10 Release the blue locking lever.
11 Install a PCI add-in card, if desired. For instructions, see
“Installing
a PCI Add-in Card.”
12 Position the riser assembly over the PCI sockets on the server board
(see letter “A” in the figure below), lining up the four hooks at the
rear of the riser assembly (see letter “B”) with the four slots in the
rear of the chassis (see letter “C”).
13 Push the riser assembly down until the assembly is securely seated.