Acer Altos R510 - Manual (Page 68)

4 Configuring the system 56
drive power adapter cable used in these instructions was sent to
you with your fixed drive kit.
1 Observe the safety and ESD precautions at the beginning of this
book. See
“Safety Information.”
2 Power down the server and unplug all peripheral devices and the
AC power cable.
3 Remove the chassis cover. For instructions, see “Removing the
Chassis Cover.”
4 Remove the front bezel if it is installed. For instructions, see
“Removing and Installing the Front Bezel.”
5 Align the two holes at the left side of the floppy drive with the
two cutouts in the floppy drive carrier. See letter “A” in the figure
below.
6 Lower the right side of the floppy drive into the carrier until it
clicks into place. See letter “B” in the figure below.
7 Open the connector on the rear of the floppy drive by pulling up
on the connector cover. See letter “A” in the figure below.
8 Insert one end of the 26-pin flat flex cable end into the connector.
See letter “B” in the figure below.
A
B