Acer Altos R510 - Manual (Page 162)

6 Troubleshooting 150
System Cooling Fans Do Not Rotate Properly
If the system cooling fans are not operating properly, it is an indication
of possible system component failure.
Check the following:
• Is the power-on light lit? If not, see “Power Light Does Not Light”
• If your system has LED lights for the fans, is one or more of these LEDs lit?
• Are any other control panel LEDs lit?
• Have any of the fan motors stopped? Use the server management
subsystem to check the fan status.
• Have your fans speeded up in response to an overheating situation?
• Have your fans speeded up in response to a fan that has failed?
• Are the fan power connectors properly connected to the server board?
• Is the cable from the control panel board connected to the both the
control panel board and to the server board?
• Are the power supply cables properly connected to the server board?
• Are there any shorted wires caused by pinched-cables or have power
connector plugs been forced into power connector sockets the wrong way?
Diskette Drive Activity Light Does Not Light
Check the following:
• Are the diskette drive’s power and signal cables properly installed?
• Are all relevant switches and jumpers on the diskette drive set correctly?
• Is the diskette drive properly configured?
• Is the diskette drive activity light always on? If so, the signal cable may be
plugged in incorrectly.
If you are using the onboard diskette controller, use the BIOS setup to
make sure that “Onboard Floppy” is set to “Enabled.” If you are using
an add-in diskette controller, make sure that “Onboard Floppy” is set
to “Disabled.”
CD-ROM Drive or DVD/CD-RW Drive Activity Light Does
Not Light
Check the following:
• Are the CD-ROM/DVD/CD-RW drive’s power and signal cables properly
installed?
• Are all relevant switches and jumpers on the drive set correctly?