Armasight ANKI000049 AIM PRO-L Advanced Integrated Mount - Manual (Page 39)

39
5. Slightly dampen a cotton swab with ethanol and gently, slowly wipe down
the glass surfaces. Clean the glass surfaces using circular movements, start-
ing from the center and moving out towards the edge, without touching
the prism or lens holder. Change the cotton swab after each circular stroke.
Repeat until the glass surfaces are clean.
6. Clean the battery contact surfaces and contact springs with a pencil eraser
and/ or alcohol-dampened cotton swabs.
CAUTION:
Thoroughly dry each item before placing them into the storage carton.
4.3.3 BORESIGHT TESTING
Perform boresight testing:
— When the AIM-PRO is mounted to a weapon for the first time;
— After the first firing and after each 3-5 firings;
— After repair of the AIM-PRO/ weapon;
— As the need arises (in case of systematic inaccuracy or missing the tar-
get).
Test the AIM-PRO boresight as per Part 3.3.2.
4.3.4 BATTERY REMOVAL AND REPLACEMENT
Refer to Part 3.1.1 for battery installation procedures.
4.4 RETURN INSTRUCTIONS
For service, repair or replacement of your device, send an email to
[email protected].
To assist the Service Representative (SR) in determining if the item is repair-
able, please provide the following information:
1. Serial Number of the defective item (this is engraved on the collimator
body).
2. Thorough description of the malfunction, defect or damage.
3. An explanation of how the malfunction, defect or damage occurred, if
known.
If the SR determines that the item is under warranty or should be returned
for repair, a Return Material Authorization number (RMA#) will be provided.
RMA can be obtained by sending an e-mail to [email protected]; via
phone, by calling Armasight Customer Service at (888)959-2259 Ext. 2; or via
fax, by dialing (888)959-2260.