Armasight ANKI000049 AIM PRO-L Advanced Integrated Mount - Manual (Page 30)

30
A
B
C
FIGURE 3-12. BORESIGHT ADJUSTMENT SCREWS
A. Boresight Adjustment in the Daytime with the Aiming Rest
To visually adjust the AIM-PRO boresight in the daytime, do the following:
1. Mount the AIM-PRO to a weapon.
2. Locate a target at the fire adjustment range (100m).
3. Take AIM-PRO at the center of the target using the weapon’s iron sight;
secure the weapon in the aiming rest.
4. Unscrew the protective caps from the LOCK screw and the boresight ad-
justment screws.
5. Loosen the AIM-PRO LOCK screw with a screwdriver.
6. Turn on the AIM-PRO in DAY mode. Adjust the brightness level of the aim-
ing mark.
7. With both eyes open, take aim at the target. Use a screwdriver to turn the
windage and elevation adjustment screws until a red dot appears in the
center of your field of view. Shift the dot to the center of the target. .
8. After you have completed the boresight adjustment procedure, tighten
the LOCK screw and replace the protective caps.
B. Boresight Adjustment in the Daytime with the Adjustment Disk
To adjust the AIM-PRO boresight in the daytime using the Adjustment Disk,
do the following:
1. Mount the AIM-PRO to a weapon.
2. Locate a target at the fire adjustment range (100m).
3. Turn on the AIM-PRO in DAY mode. Adjust the brightness level of the aim-
ing mark.
4. Take aim by centering the aiming mark of the device on the target, and
fire a series of shots (3-4).