Asus GigaX2048 User Manual
Gigax series, Layer 2 managed switch user guide
This manual is related to the following products:
Table of contents
Document Outline
- ASUSTeK COMPUTER INC. (Asia-Pacific)
- Technical Support
- ASUS COMPUTER INTERNATIONAL (America)
- ASUS COMPUTER GmbH (Germany and Austria)
- 1 Introduction
- 2 Getting to know the GigaX
- 3 Quick start guide
- 4 Management with the Web Interface
- 5 Console Interface
- 5.1 Power On Self Test
- 5.2 Login and Logout
- 5.3 CLI Commands
- 5.3.1 System Commands
- 5.3.2 Physical Interface Commands
- 5.3.3 Bridge Commands
- [Spanning Tree is] [STP Enabled/ RSTP Enabled/ Disabled]
- [Hello Time] [Forward Delay] [Max Age] [Bridge Priority]
- Hello Time (1..10 seconds):[old Hello Time]
- [Retrieve]
- [Show Trunk]
- [Create Trunk]
- [Add/Remove Trunk]
- [LACP Action]
- [LACP System Priority]
- [LACP Port Priority]
- **For GigaX 2048
- [Mirror] [Mirror 1/Mirror 2]
- [Retrieve]
- [Show Multicast Group]
- [Set Multicast Group]
- [Remove Multicast Group]
- [Retrieve]
- [Retrieve]
- [Broadcast] [Enabled/Disabled]
- [Multicast] [Enabled/Disabled]
- [Limit]
- [Retrieve]
- [Aging Time]
- [Query by Port]
- [Query by VLAN ID]
- [Query by MAC Address]
- [MAC Address]
- [VLAN ID]
- [Port Selection]
- [Discard] [none/source/destination/source & destination]
- [Retrieve]
- [Show VLAN]
- [Name]
- [VLAN ID]
- [DHCP Snoop]
- [Remove VLAN]
- [Retrieve]
- [PVID]
- [Retrieve]
- [Priority] [CoS Queue]
- [Retrieve]
- [DHCP Snooping is]
- [Add/Remove Trusted Port]
- [Retrieve]
- 5.3.4 SNMP
- [Community Name] [Set]
- [Retrieve]
- [Host IP Address] [Community]
- [Retrieve]
- [Trap Version] [v1/v2c]
- [Destination]
- [Community for Trap]
- [Retrieve]
- [Group Name]
- [Read View Name]
- [Write View Name]
- [Notify View Name]
- [Security Model]
- [Security level]
- [Retrieve]
- [View Name]
- [View Type]
- [View Subtree]
- [View Mask]
- [Retrieve]
- [Engine Id]
- [Name]
- [Auth Protocol]
- [Auth Password]
- [Priv Protocol]
- [Priv Password]
- [Retrieve]
- 5.3.5 Filters Commands
- [New]
- [Remove]
- [Edit]
- [Rule Mode] [MAC Rule]
- [Action] [Permit/Deny]
- [Source MAC]
- [Destination MAC]
- [Add]
- [Rule Mode] [IP Rule]
- [Action] [Permit/Deny]
- [Source IP] [Type/IP, Mask]
- [Destination IP] [Type/IP, Mask]
- [Source Port] [Type/Port]
- [Destination Port] [Type/Port]
- [Protocol] [ICMP/TCP/UDP/ANY]
- [Add]
- [Rule Mode] [MAC Rule]
- [Action] [Permit/Deny]
- [Source MAC]
- [Destination MAC]
- [Modify]
- [Rule Mode] [IP Rule]
- [Action] [Permit/Deny]
- [Source IP] [Type/IP, Mask]
- [Destination IP] [Type/IP, Mask]
- [Source Port] [Type/Port]
- [Destination Port] [Type/Port]
- [Protocol] [ICMP/TCP/UDP/ANY]
- [Modify]
- [Rule Mode] [MAC Rule]
- [Action] [Permit/Deny]
- [Source MAC]
- [Destination MAC]
- [Delete]
- [Rule Mode] [IP Rule]
- [Action] [Permit/Deny]
- [Source IP] [Type/IP, Mask]
- [Destination IP] [Type/IP, Mask]
- [Source Port] [Type/Port]
- [Destination Port] [Type/Port]
- [Protocol] [ICMP/TCP/UDP/ANY]
- [Delete]
- [Rule List]
- [Filter ID]
- [Ingress Port]
- [Egress Port]
- [Retrieve]
- 5.3.6 Security Commands
- [Reauthentication]
- [Reauthentication Time]
- [Authentication Method]
- [Quiet Period]
- [Retransmission Time]
- [Max Reauthentication Attempts]
- [Multi-host]
- [Authentication Control]
- [Retrieve]
- Allows user to modify a user entry from the local database. It contains a user name, password and dynamic VLAN.
- [Retrieve]
- [Retrieve]
- [Generate SSH key]
- [Reset SSH key]
- [Show Generating Status]
- [Admin] [Enable/Disable]
- CLI command: security portsecu admin
- [Violation Mode] [Protect/Restrict/Shutdown]
- [Max MAC Addresses]
- [Aging Time]
- [Aging Type] [Absolute/Inactivity]
- [Restart]
- [Port Selection]
- [Query]
- [MAC Address]
- [Port Selection]
- [Add]
- [Remove]
- [Retrieve]
- 5.3.7 QoS Commands
- [State] [No/CoS/DSCP]
- [CoSOverride] [Disable/Enable]
- [CoS to DSCP]
- [DSP to CoS]
- [Class Name]
- [Match][None/Filter/DSCP]
- [Filter Set ID]
- [DSCP][0/8/10/16/18/24/26/32/34/40/46/48/56]
- [Add]
- [Modify]
- [Remove]
- [Policy Name]
- [Add]
- [Remove]
- [Edit]
- [Class ID]
- [DSCP]
- [Traffic Rate]
- [Traffic Burst Size]
- [Exceed Action][None/Drop/DSCP]
- [Exceed DSCP]
- [Add]
- [Modify]
- [Remove]
- [Policy ID]
- [Attach/Detach]
- [Retrieve]
- [Scheduling Algorithm]
- [CoS Queue ][Weight]
- [Priority] [CoS Queue]
- 5.4 Miscellaneous Commands
- 6 IP Addresses, Network Masks, and Subnets
- 7 Troubleshooting
- 8 Glossary
- 9 Index