Asus GigaX2048 - Manual (Page 111)

GigaX Series L2 Managed Switch User Guide
CLI command: sys web set
[New Password]
[Verify Password]
The default user name is admin. By default, a password is not required.
You may set a password by configuring these fields.
CLI command: sys users modify
user name (old user name, ‘admin’ by default):
password (old password ):
[Reboot]
User can reboot the switch by issuing the reboot command.
CLI command: sys reboot
[Upload]
No CLI command for this function. Refer to Boot ROM commands for this
function.
5.3.2 Physical Interface Commands
[Admin] [Enable/Disable]
Displays the port admin status, allow user to turn the port on or off.
CLI command: l2 port admin
[Mode] [Auto/10M-Half/10M-Full/100M-Half/100M-Full/1G-Full]
Displays the current speed and duplex mode of the port. The speed and
duplex mode can be automatically detected when auto-negotiation is
enabled on a port.
CLI command: l2 port autoneg
CLI command: l2 port speed <10/100/1000>
CLI command: l2 port duplex