Asus GigaX2048 - Manual (Page 131)

GigaX Series L2 Managed Switch User Guide
[Rule Mode] [IP Rule]
[Action] [Permit/Deny]
[Source IP] [Type/IP, Mask]
[Destination IP] [Type/IP, Mask]
[Source Port] [Type/Port]
[Destination Port] [Type/Port]
[Protocol] [ICMP/TCP/UDP/ANY]
[Add]
User can add a new IP rule associated to a filter set. This filter rule works with
ICMP, TCP or UDP protocols with permit or deny options. User can also
specify the IP address (source or destination) and port number of the filter rule
using the CLI command dstip/srcip and dstport/srcport, respectively.
CLI command: filter rule new ICMP/TCP/UDP/any>
CLI command: filter rule dstip [subnet])>
CLI command: filter rule srcip [subnet])>
CLI command: filter rule dstport
CLI command: filter rule srcport