SENA ProBee-ZE20S-HAOL User Manual
Page 72

ProBee-ZE20S-HAxx User Guide Rev 1.9
72
8.1.3
S13
Description
Get/Set the command responses mode.
Execute
ATS13?
ATS13=
Response
OK
OK
Default
1
Range
0 - 1
8.1.4
S14
Description
Get/Set the LED mode. It causes the LED operation if the device is ZE20S set
GPIO15, 16 to specific functionality.
0: LEDs are always OFF regardless of configuration or status.
1: LEDs are OFF when the node is under sleep status.
2: LEDs always operate by the case.
Execute
ATS14?
ATS14=
Response
OK
OK
Default
1
Range
0 - 2
8.2
Network Settings
8.2.1
S22
Description
Get/Set the timeout to permit joining. It determines the time in seconds that the device
will allow other devices to join to it when it starts network but an end-device cannot
perform it. If set to 255, the device will always permit joining.
Execute
ATS22?
ATS22=
Response
OK
OK
Default
255
Range
0 - 255
8.2.2
S23
Description
Get/Set the power boost mode of the module. If enabled, boost mode improves
sensitivity and increases output power, improving the link margin and range.
Execute
ATS23?
ATS23=
Response
OK
OK