SENA ProBee-ZE20S-HAOL - Manual (Page 65)

ProBee-ZE20S-HAxx User Guide Rev 1.9 65
Default 0
Range 0 – 2
7.9.4 AT+STOPBIT or AT+US
Description Get/Set the serial stop bit setting on the module.
Execute AT+STOPBIT? AT+STOPBIT=
Response
OK
OK or ERROR
Default 1
Range 1 – 2
7.9.5 AT+FLOWCTRL or AT+UF
Description Get/Set flow control status. (0: none, 1: software, 2: hardware flow control)
Execute AT+FLOWCTRL? AT+FLOWCTRL=
Response
OK
OK or ERROR
Default 0
Range 0 – 2
7.10 GPIO
7.10.1 AT+GPIO or AT+IO
Description
Get/Set the configuration status of GPIO individually or all at once. Only GPIO9-
14 can be set 0-5, others are available 0-3 and 5.
Execute
AT+GPIO? or
AT+GPIO?
AT+GPIO= or
AT+GPIO=
Response
OK
OK or ERROR
Default 55555000000000055
Range
GPIO9-14: 0-6, the others: 0-3 and 5-6
0 Disabled (unmonitored digital input)
1 Digital input, monitored
2 Digital output, default low
3 Digital output, default high
4 Analog input, single ended (only valid for GPIO9~14)
5 Reserved for pin-specific alternate functionalities
6 Home Automation GPIO (only valid for ProBeeHADL and ProBeeHAOL)
7.10.2 AT+DIO
Description Get/Set the digital IO value individually or all at once. All GPIO pins can be used