SENA ProBee-ZE20S-HAOL User Manual
Page 59
ProBee-ZE20S-HAxx User Guide Rev 1.9
59
7.4
Network Specific Parameters
7.4.1
AT+CHMASK or AT+CM
Description
Get/Set the channel mask to use. Bits set as 1 indicate that this particular
channel can be used. Bits set as 0 indicate that this particular channel should not
be used. For example, a channel mask value of 0x00000001 indicates that only
channel 0 should be used. Valid channels range from 11 to 26 inclusive. (16
channels are available.) This translates to a channel mask value of
“0x07FFF800”.
Execute
AT+CHMASK?
AT+CHMASK=
Response
OK
OK
Default
07FFF800
Range
00000800 - 07FFF800
7.4.2
AT+PANID or AT+PI
Description
Get/Set the 16-bit PAN ID. If it is set to 0s at a coordinator, the coordinator will
select a random 16-bit hexadecimal number as PAN ID. If it is set to 0s at a
router/end-device, the router/end-device will try to join any existing network
regardless of PAN ID.
Execute
AT+PANID?
AT+PANID=
Response
OK
OK
Default
0000
Range
0000 – FFFF
7.4.3
AT+EPID or AT+EI
Description
Get/Set the 64-bit extended PAN ID. If the node is a coordinator and the EPID is
set to 0s, it will create new extended PAN ID using its 64-bit IEEE address as
extended PAN ID. If the node is a router or end-device and the EPID is set to 0x,
it will try to join any existing network regardless of extended PAN ID.
Execute
AT+EPID?
AT+EPID=
Response
OK
OK
Default
0000000000000000
Range
0000000000000000 – FFFFFFFFFFFFFFFF
7.4.4
AT+GROUPID or AT+GI
Description
Get/Set the 16-bit Group ID. It is used for multicast data reception.
Execute
AT+GROUPID?
AT+GROUPID=