SENA ProBee-ZE20S-HAOL User Manual
Page 60

ProBee-ZE20S-HAxx User Guide Rev 1.9
60
Response
OK
OK
Default
0000
Range
0000 – FFFF
7.4.5
AT+POWER or AT+PW
Description
Get/Set the TX power at which the RF module transmits conducted power.
Execute
AT+POWER?
AT+POWER=
Response
OK
OK
Default
8
Range
-43 – 8
7.4.6
AT+STACK or AT+ZS
Description
Get/Set the ZigBee stack profile value. This value must be set the same on all
devices that should join the same network. (0: Network specific, 1: ZigBee, 2:
ZigBee Pro)
Execute
AT+STACK?
AT+STACK=
Response
OK
OK
Default
2
Range
0 – 2
* Default value changed 2 from 0
7.4.7
AT+NODENAME or AT+NN
Description
Get/Set the node name. It can be used to make a clear distinction role or
functionality of local node from others.
Execute
AT+NODENAME?
AT+NODENAME=
Response
OK
OK
Default
ProBee-HAxx
Range
Up to 16 characters
7.5
Network Formation and Join
7.5.1
AT+ASCAN or AT+AS
Description
Perform a scanning for existing network. It can take up to 5 seconds. (CAUTION:
It is possible to cause a link error if a node is a parent of an end-device.)
Execute
AT+ASCAN
AT+ASCAN=
Response