SENA ProBee-ZE20S-HAOL - Manual (Page 66)

ProBee-ZE20S-HAxx User Guide Rev 1.9 66
as digital IO and it is only possible to set 0 or 1. If there are some pins used
analog input, they are displayed by “*”.
Execute
AT+DIO? or
AT+DIO?
AT+DIO= or
AT+DIO=
Response
OK
OK or ERROR
Default 00000000000000000
Range 00000000000000000 – 11111111111111111
7.10.3 AT+AI
Description
Get the analog input value individually or all at once. GPIO9~14 are possible to
set ADC and it’s read only. If there are some pins used digital IO, they are
displayed by “****”.
Execute AT+AI? AT+AI?
Response
,,,
OK OK
7.10.4 AT+SOURCELA or AT+SL
Description
Get/Set the 64-bit source IEEE address for GPIO remote control. It is possible to
limit on the implementation of this functionality by setting specific address. If set
to default value, “FFFFFFFFFFFFFFFF”, the node allows that any node can
control the GPIO status.
Execute AT+SOURCELA? AT+SOURCELA=
Response
OK
OK or ERROR
Default FFFFFFFFFFFFFFFF
Range 0000000000000000 – FFFFFFFFFFFFFFFF
7.11 Firmware Upload and Help
7.11.1 AT+BOOTLOAD or AT+BL
Description
Start bootloader to upload firmware. (blank: local, 1: passthru)
The device leaves the AT command line and enters the bootloader menu for
uploading new ProBee firmware. There’s no restrict to use local upload but a
sleepy end-device cannot upload to remote node over the air. The current UART
should be set 115200bps, 8 data bits, no parity, 1 stop bit and none flow control.
Execute AT+BOOTLOAD AT+BOOTLOAD=,
Response
Bootloader menu
…
Serial upload complete
Please start .ebl upload image ... or
Start cloning ...
Bootloader menu