QTECH QSW-2800 Инструкция по настройке - Manual (Page 67)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
53
show loopback-detection
[interface ]
Display the state and result of the loopback detection
of all ports, if no parameter is provided; otherwise,
display the state and result of the corresponding ports.
5. Configure the loopback-detection control mode (automatic recovery enabled or not)
Command Explanation
Global Mode
loopback-detection control-
recovery timeout <0-3600>
Configure the loopback-detection control mode
(automatic recovery enabled or not) or recovery time.
6.3 Port Loopback Detection
Function Example
Typical example of port loopback detection
As shown in the above configuration, the switch will detect the existence of loopbacks in the
network topology. After enabling the function of loopback detection on the port connecting the
switch with the outside network, the switch will notify the connected network about the
existence of a loopback, and control the port on the switch to guarantee the normal operation
of the whole network.
The configuration task sequence of SWITCH:
Switch(config)#loopback-detection interval-time 35 15
Network
Topology
SWITCH