QTECH QSW-2800 Инструкция по настройке - Manual (Page 279)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
265
}] [ack+fin+psh+rst+urg+syn]
[precedence ] [tos ][time-range
range-name>]
using this number.
access-list {deny | permit} udp {{
} | any-source | {host-source }} [s-
port { | range }]
{{ } | any-destination | {host-
destination }} [d-port { | range
}] [precedence ] [tos
][time-range]
Creates a numbered UDP
extended IP access rule; if the
numbered extended access-list of
specified number does not exist,
then an access-list will be created
using this number.
access-list {deny | permit} {eigrp | gre | igrp |
ipinip | ip | ospf | } {{
} | any-source | {host-source }}
{{ } | any-destination | {host-
destination }} [precedence ] [tos
][time-range]
Creates a numbered IP extended
IP access rule for other specific IP
protocol or all IP protocols; if the
numbered extended access-list of
specified number does not exist,
then an access-list will be created
using this number.
no access-list
Deletes a numbered extensive IP
access-list.
(3) Configuring a standard IP access-list basing on nomenclature
a. Create a name-based standard IP access-list
Command Explanation
Global Mode
ip access-list standard <name>
no ip access-list standard <name>
Creates a standard IP access-
list based on nomenclature; the
“no ip access-list standard
<name> “ command deletes the
name-based standard IP
access-list.
b. Specify multiple “permit” or “deny” rules
Command Explanation
Standard IP ACL Mode
[no] {deny | permit} {{ } | any-source
| {host-source }}
Creates a standard name-based
IP access rule; the “no” form
command deletes the name-
based standard IP access rule.
c. Exit name-based standard IP ACL configuration mode
Command Explanation