QTECH QSW-2800 Инструкция по настройке - Manual (Page 286)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
272
[no]{deny|permit}{any-source-mac|{host-source-
mac}|{}} {any-
destination-mac|{host-destination-mac
}|{}}udp
{{}|any-source| {host-
source}} [s-port { | range
}]
{{}|any-
destination| {host-destination }}
[d-port { | range }]
[precedence ] [tos ][time-
range]
Creates an extended name-based
MAC-UDP access rule; the no
form command deletes this name-
based extended MAC-UDP access
rule.
[no]{deny|permit}{any-source-mac|{host-source-
mac}|{}} {any-
destination-mac|{host-destination-mac
}|{}}
{eigrp|gre|igrp|ip|ipinip|ospf|{}}
{{}|any-source| {host-
source}}
{{}|any-
destination| {host-destination}}
[precedence][tos][time-
range]
Creates an extended name-based
access rule for the other IP
protocol; the no form command
deletes this name-based extended
access rule.
c. Exit MAC-IP Configuration Mode
Command Explanation
Extended name-based MAC-IP access Mode
exit
Quit extended name-based MAC-IP access
mode.
(10) Configuring a numbered standard IPv6 access-list
Command Explanation
Global Mode
ipv6 access-list {deny | permit}
{{ <sPrefixlen>} | any-source |
{host-source }}
no ipv6 access-list
Creates a numbered standard IPv6 access-
list, if the access-list already exists, then a
rule will add to the current access-
list; the “no
access-list “ command deletes a
numbered standard IPv6 access-list.
(11) Configuring a standard IPv6 access-list based on nomenclature